OSHA Training in Grand Junction CO

OSHA Training in Grand Junction Colorado

Worker safety for private companies in Grand Junction and the rest of Colorado is regulated by the Federal Occupational Safety and Health Administration (OSHA). The state of Colorado does not operate an approved state OSHA program for public employees at the state or political sub-division (e.g.: municipal) level.

OSHA Regulations and Standards

Regulated employers located in the state of Colorado are governed by the Federal OSHA health and safety standards found in the 29 Code of Federal Regulations (CFR). These include, but are not limited to, the OSHA workplace poster requirements in Part 1903, OSHA injury and illness recordkeeping requirements in Part 1904general industry standards in Part 1910, maritime standards in Parts 1915, 1917 and 1918, construction standards in Part 1926, and agricultural standards in Part 1928. 

Jurisdiction

Federal OSHA exercises jurisdiction over most private employers in the state of Colorado. Federal employers in CO also operate under the jurisdiction of Federal OSHA. There are two OSHA area offices in the state to serve Grand Junction and the rest of Colorado:

Denver Area Office (Northern CO)
1391 Speer Boulevard, Suite 210
Denver, CO  80204
(303) 844-5285

Englewood Area Office (Southern CO)
7935 East Prentice Avenue, Suite 209
Englewood, CO 80111
(303) 843-4500

The OSHA national emergency hotline telephone number is 1-800-321-OSHA.

Other Resources

State of Colorado OSHA Poster

OSHA Training Requirements for 1910 General Industry

OSHA Training Requirements for 1926 Construction

 

back >


Disclaimer: This information was originally obtained from the Federal OSHA website. OSHA Training Services Inc. makes every effort to ensure that the information on this page is accurate and up to date, but changes in state law and procedures affecting the information on this page are beyond our control. Contact state program staff directly to verify important information.

 

 

 

OSHA 10 hour training Grand Junction CO

OSHA 30 hour training Grand Junction CO

Confined space entry training Grand Junction CO

Excavation competent person training Grand Junction Colorado

 

Need OSHA Training in Grand Junction Colorado?


Contact

HP&P Safety

 

Offering the following on-site OSHA training courses for your group throughout Northern Colorado:

OSHA 10 Hour Training - Construction

OSHA 10 Hour Training - General Industry

OSHA 30 Hour Training - Construction

OSHA 30 Hour Training - General Industry

Competent Person Training for Excavations

Confined Space Entry Training

H2S Gas Safety

Fall Protection

NFPA 70E / Arc Flash

Hazwoper Training

. . . and a whole lot more!

osha_request_proposal.gif

 or call 303-360-9801

 

 

CLICK HERE to see our Open Enrollment Training Calendar

 

 

 

 

 

The advertiser above is not employed by OSHA Training Services Inc. We are providing the information above strictly as a service for visitors to our website. We are not responsible for, and in no way warrant, the services provided by the advertiser. You should confirm the trainer’s qualifications and credentials when contacting them about their services.